either in the top cover opening operation after pressing the 2 springs or by leaving or spilling any improper materials inside after the opening operation.
POWER ADAPTOR
The power connector resides in the lower left corner of main connector area. Please make sure that the cable from the power adaptor is inserted into the power connector of PB system in the correct orientation
as illustrated in right drawing. The manufacturer is not responsible for any damage caused by improper orientation of this connection. Please check that for
straight type power plug the arrow mark on the plug is at top side of the plug. For right angled power plug, if the arrow mark is on its end, it should be pointing up. If the arrow mark is on one side of the right angled power plug, it should be on the right as in the drawing. Please
also check that the city power supply specification from the wall socket is within the operation range of the power adaptor.
UPS BATTERY (OPTION)
When the PB system is installed with the UPS battery, the UPS battery is in the carton at delivery. Please take it out and place it in the battery compartment at center upper part of the connection area indicated as upper rectangle in picture at right. Connect the cable
to its connector in the main connection area
beside the power connector only when the system is about to power up for operation. Always disconnect the UPS battery when the
system is to be left powered off for more than few days. Please pay particular attention to the environment requirement for UPS battery in next chapter “USING THE PB SYSTEM”.
SIDE MOUNT UPGRADE KIT (OPTION TO TM/LM-7112)
When a
Part 7