WIRING DIAGRAM:

IS-MV

 

IS-CCU

 

 

 

 

 

 

 

CAT-5e

IS-PU-UL

IS-DVF-HID

 

 

 

CAT-5e

 

 

 

 

NO

COM

NC

To Strike

& Power

TESTING & OPERATION:

Connect the reader to the host according to the wiring table below and the host installation guide.

Wiegand Wire

Color

 

 

+ DC (5-16V)

Red

Ground

Black

Data0

Green

Data1

White

Shield Ground

Drain

Green LED

Orange

Red LED

Brown

Beeper

Yellow

Hold

Blue

Card Present

Violet

 

 

When power is applied to the card reader, the LED will flash green three (3) times while the beeper beeps simultaneously. The LED will then turn red. This indicates that the microcontroller is operating properly.

Present an ID card to the reader (hold card directly in front of reader). The LED will momentarily turn green while the beeper beeps once, indicating that the card was read successfully.

SPECIFICATIONS:

CARD READER:

 

CAMERA:

 

Reader type:

6005B ProxPoint Plus

Camera unit:

CMOS camera

Power Source:

5 ~ 16V DC

Scanning line:

525 lines

Max Voltage:

18V DC

Min. illumination:

5 Lux at 1’6”

Current:

30mA (Avg); 75mA (peak)

Terminations:

RJ45 jack for audio/video

Terminations:

Color-coded pre-wired pigtail

 

Screw terminals for door release

Wiring Distance:

500’

Operating Temp:

14° ~ 140°F / -10° ~ 60°C

Operating Temp:

14° ~ 140°F / -10° ~ 60°C

Wiring Distance:

980’ with Cat5e/6 cable

Operating Humidity:

0-95% relative humidity

Dimensions:

12-3/8” H x 7” W

 

non-condensing

w/SBX-ISDVFP:

12-7/16” H x 7-1/16” W x 2-13/16” D

 

 

 

(top), 1-13/16” D (bottom)

Aiphone Corporation

1700 130th AVE NE

Bellevue, WA 98005

(425)455-0510 Fax: (425) 455-0071

FCC WARNING:

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference that may cause undesired operation.

For proper regulatory compliance, the drain wire should be disconnected at the power supply end of the cable.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

The Reader is intended to be powered from a limited power source output of a previously certifed power supply

TOLL FREE TECHNICAL SUPPORT:

(800) 692-0200

E-MAIL: tech@aiphone.com

Pg. 2 IS-DVF-HID Instr. 0311JD

Page 2
Image 2
Aiphone IS-DVF-HID dimensions Wiring Diagram, Testing & Operation, Specifications, Card Reader Camera