4Installing and removing the paper roll
Recording paper specifications
Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls than specified could cause paper jamming, resulting in register malfunction.
Paper specification |
|
Paper width: | 44.5 ± 0.5 mm |
Max. outside diameter: 80 mm | |
Weight: | 52.3 — 64.0 g/m 2 |
Quality: | bond paper |
Paper tube: | 18 mm |
• Be sure to set paper roll(s) prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
(How to set the paper roll) | (How to cut the paper end) |
To the printer
Incorrect
Paper replease lever
To the printer
Correct
CorrectIncorrect
To release the paper, press the paper release lever down. It is also used for removing a paper jam. The method for removing a paper jam is described in “Removing a paper jam” later in this section.
Receipt side | Journal side |
Installing the paper roll
Installing the receipt paper roll
1.Turn the mode switch to the “REG” position with the AC cord connected.
2.Remove the printer cover.
3. Set the paper roll correctly and drop it into the printer.
4.Press the receipt paper release lever down and insert the
paper end into the paper chute of the printer.
5.Pull the paper end that has come out of the printer, holding down the lever.
6. Advance the paper by a required length by pressing the receipt paper feed key.
7. Replace the printer cover.
