Air King AK100LSL Plug, Screws, Venturi, Screw Wire, Supply from Lamp Holder Bulb House Socket

1b. Internal Wire Compartment: Remove the three screws holding			NOTE: The fan’s receptacle wires might need to be pulled outside
	the blower assembly in place and lift assembly out of housing		compartment for connection. Only pull the three loose wires
	(Figure 6). Remove the wire compartment cover screw and		outside of compartment. Additional wires will be present.
	place the cover in a secure place (Figure 7).		4. Carefully tuck wires back inside wire compartment and
			replace wire compartment cover securing with the screw
			that was removed earlier.
		Plug

	SECTION 6
	Completing the Installation
Screws	1.	If the fan’s blower assembly was removed during the wiring
Venturi		process, reinstall the blower by reversing the directions in
		Step 1b in Section 5 Wiring.
Figure 6	2.	Plug the fan’s quick connect motor cord into the receptacle.
		This cord will only fit one way into the receptacle (Figure 9).

NOTE: If the fan motor plug	Screw	Wire
is connected to the fan
housing receptacle, unplug		Compartment
so the blower assembly can		Cover
be completely removed.
	Figure 7
2. Run wiring from an approved wall switch carrying the			Figure 9
appropriate rating. One neutral (white), one ground (green

or bare copper), and three hot (black, purple, yellow leads	3. Install the two included 13 watt fluorescent bulbs into the
connected to the switch, one for each function). Secure the		lamp holders by lining up the pins on the bulb base to the
electrical wires to the housing with an approved electrical		socket of the lamp holder and pressing towards the lamp
connector. Make sure you leave enough wiring in the box to		holder until the bulb snaps into place and is firmly seated in
make the connection to the fan’s receptacle.		the lamp holder. Install a 4 watt maximum type C7 (candelabra
3. From where you have chosen to access the fan’s junction		base) night light (not included) into the side lamp holder
		(Figure 10).
box, connect the White wire from the house to the two White
wires from the fan. Connect one Hot (Black) wire from the
wall switch to the Black wire from the fan (this is the fan			Night Light
control). Connect second Hot (Purple) wire from the wall
switch to the Purple wire from the fan (this is the main light
control). Connect the third Hot (Yellow) wire from the wall
				Pin
switch to the Yellow wire from the fan (this is the night light
control). Connect the ground wire from the house to the
Green wire from the fan (Figure 8). Use approved methods
for all connections.

Supply from		Lamp Holder	Bulb
house
			Socket
		Figure 10
		4. Install the grill by squeezing the two ends of the springs
		together and installing them up into the slots on the fan’s
White	Hot	housing. Push the grill up into position (Figure 11).
		Hot
	(Black)
		(Purple)
Ground
		Hot (Yellow)
Figure 8
210572080 Rev. A 8-05		www.airkinglimited.com		3 of 12