9
3. Power Adapter Connection
Plug the power adapter into a wall outlet. Connect the other end to the
“DC IN” Jack on the device.
4. Analog Pass Through
Analog pass-through is enabled when you connect your TV following
Section 6-2 (RF Cable). This device will pass through analog TV
signals from ‘‘ANT IN’’ to ‘‘RF OUT.’’
To use the analog pass through feature:
4.1 Install the unit as described in Section 6-2, 2.1 using the RF cable.
4.2 Use the Menu to turn the ‘‘Loop Through’’ option to ON as
described in section 8-5.5 of this manual.
4.3 Turn off the power by pressing the power button on the device.
The device is in ‘‘Stand-by’’ mode when the red light is on.
Ensure that your device is properly connected to your television as
described in 6.2 above, that you have inserted the batteries into the
remote and that the signal quality is good.
Press the power button on the device or remote control to activate the
device.
Follow the Installation Guide below to perform channel scanning.
Note: If the Installation Guide below does not show on your TV screen,
please go to 6-5. Manual Installation
1. Select your Language.
The default language for the On Screen Menu (OSM) is set to English.
Press Left/Right to choose another display language: English, Spanish,
French.
Power Button