●INSTALLATIONS

Precautions

Select the mounting location very carefully, referring to the following points.

●Make sure that there is no fuel tank, wiring or piping on the other side of the mounting surface.

●Make sure that the installation of the unit will not hinder the movement of the deck lid or interfere with the spare tire, etc.

●Use only the supplied mounting kit for safe and proper installation.

Mounting angle setting levers

Be sure to change the position of both mounting angle setting levers according to the angle at which the unit is to be installed.

Mounti~g angle setting levers

Removing the transpotl screws

Find the three transport screws at the bottom of theunit, which lockthe unit’smechanism during

transport. Remove these screws before installation.

Retain these screws and replace them in the original positions if the unit is transported for service or maintenance.

 

45’

45

Q

 

RIZONTAL

 

HORIZONTAL

n

‘if

0

 

 

 

“g

Insert a ~ointed obiect such as a screw driver or ball-pointpen, etc.-into the low spot of the lever and slide the lever to the position from among HORIZONTAL, 45°, and VERTICAL positions.

Notes

. Be sure to eject the disc magazine when you set the levers.

●Be sure to set both levers to the same position.

●Be sure to set the levers exactly at the position (notch). If the lever is deviate from the position, the sound may drop out.

●Care must be taken when you mount the unit at the angle of lower than level. The disc magazine may drop if you eject the magazine.

●Do NOT turn over the unit or slide the lever when the unit is activated. Doing so maydamagethe mechanism or the discs in the unit.

●The mounting angle setting levers on each side of the unit are factory-set to the HORIZONTAL position.

●When you complete the setilng, attach the supplied adhesive labels @ over the slots.

i

do

~

,,.-,0

 

/

,,, ,,.,

@

I

;,” ,

 

 

: ,,/

 

.,

ENGLISH 4