English | Installation Precautions |
| |
an airbag system, never install it in a | |
| WARNING |
| • When installing the unit to a vehicle with |
| place where it may affect the operation of |
| the airbag. |
| • Do not install this unit in the following |
| locations: |
| A location interfering with the driver's |
| visual range or operation. |
| A location that hinders the gear shift. |
| A location where passengers are at risk. |
| An unstable location, or where the |
| system may fall. |
|
|
CAUTION
•Do not install this unit in a location exposed to rain or dust. Doing so creates the risk of a fire, accident, and electric shock.
•Do not install this unit in a place exposed to direct sunlight, heat or a place where the vent holes or heat radiation holes are covered.
Installation Notes
WARNING
Please note the position of pipes, tanks and electrical wirings before installing the unit into the vehicle; failure in avoiding these may cause a fire or malfunction.
CAUTION
•Use only the supplied parts.
•If unspecified parts are used, they may cause damage.
•Any holes made in the body of the vehicle should be sealed with a silicon adhesive.
•If exhaust fumes or water penetrates into the vehicle, this may cause an accident.
•Fasten the bolts securely when installing the unit. Loose bolts create the risk of an accident or malfunction.
Connection Notes
WARNING
•Loom all cables according to the instruction manual, so as not to hinder operation.
•Wire the connecting cords/cables away from high temperature areas. If the coatings of the cables melt, it could cause an accident/fire by a short circuit. Take care when wiring in the engine compartment.
•When installing the unit to a vehicle with an airbag system, never install it in a place where it may affect the operation of the airbag.
•An airbag not operating correctly in an emergency may cause increased injury.
CAUTION
•Connect cables appropriately. If a wrong connection is made, this may cause a fire or accident.
•When passing cables through the body of the vehicle, use
•If the coatings of the cables are worn out by rubbing, this may cause an accident, fire or a short circuit.
•After wiring cables, fix them with insulation tape.
•Be sure to switch off the vehicle when connecting or disconnecting cords to/from the unit, otherwise an electric shock, injury or accident may occur.
4 NK1U
