6NK1U
English
Installing the Car DockNote:
•
Install the Car Dock in a location where it does not
interfere with vehicle operation.
•
Install the Car Dock in a location where it does not
interfere with airbags and other safety devices.
Installing
1. There is tape affixed to the bottom of the Car
Dock, which is covered by a protection sheet.
Without removing the protection sheet, place
the Car Dock on the dashboard of the vehicle
to determine the best installation position.
Note:
Select a location where the ClarionMiND can be
attached to and removed from the Car Dock without
hitting the windshield of the vehicle. For information
about attaching and removing the ClarionMiND, see
Attaching and Removing the ClarionMiND (P.9).
2. Remove the protection sheet from the bottom
of the Car Dock and then affix the Car Dock to
the dashboard of the vehicle.
Note:
•
Use a dry cloth to wipe the installatio n location free
of dust and oil.
•
It takes about 24 hours for the adhesive tape to
achieve full adhesion.
3. Use the supplied tapping screws to secure the
two locations at the back of the Car Dock to
the dashboard.
4. Use the hex wrench to loosen the Car Dock's
hex head screw to the point of maximum tilt.
Note:
•
If the Car Dock does not tilt, you will not be able to
tighten the tapping screws with a screwdriver.
•
Fully loosen the hex screws until the Car Dock is
fully tilted. However, note that loosening the hex
screw too much can cause the hex screw to come
out.
5. Use the supplied tapping screws to secure the
two locations at the front of the Car Dock to
the dashboard.
6. Adjust the tilt of the Car Dock to the desired
angle and then tighten the hex screw to
secure it.
*Hex screw tightening torque: Use a range of 4 N⋅m
to 5 N⋅m (Approximately 0.4 kgf⋅m to 0.5 kgf⋅m) as
a general guide.
Note:
You can adjust the tilt angle of the Car Dock within a
range of 10 degrees forward, 25 degrees back, and
5 degrees horizontally.
Car Dock
Dashboard
ClarionMiND
Dashboard
Windshield
Dashboard