The Dolby Pro Logic feature and the center and surround speakers (standard) assure full-scale home theater sound. When playing back laser discs or video software that have been recorded in Dolby Surround, astonishingly realistic sound surrounds the listener to create a new level of audio/visual entertainment.

Independent control of the four channels allows the listener to enjoy the same type of sound reproduction experienced in movie theaters. Voices are reproduced in the front and center sound field, while ambient sounds like cars and crowds are reproduced on all sides of the listener for an incredibly lifelike audio/video experience. Please read the following carefully to “tune”the system’s output to match the characteristics of your listening space.

Check the following:

~Before using the DOLBY PRO LOGIC, adjust the proper balance of the speaker sound levels (see page 13).

●Make sure the speakers are properly connected and positioned (see pages 3 and 4).

●Make sure the TV set and video unit are properly connected (see page 3).

●Make sure the laser disc and video tape, etc., support

m_j@LSY5URRCUND\ .

SELECTING DOLBY PRO LOGIC

The optimal Dolby Pro Logic mode depends on the type and placement of the speakers. It is recommended that the optional Aiwa speakers should be used for all channels, for example, the SX-RI 000 for surround speakers, the SX-C1 000 for a center speaker and the SX-AVI 000 for front speakers. Check your current type and placement of the speakers and select the recommended Dolby Pro Logic mode accordingly.

The recommended mode

 

 

Center speaker

 

 

Larger-size

Smaller-size

No speaker

Surround speaker

DOLBY PRO

DOLBY PRO

PHANTOM

(Rear speaker)

LOGIC-WIDE

LOGIC-NORMAL

 

No surround

3CH LOGIC-

3CH LOGIC-

 

speaker

WIDE

NORMAL

 

PHANTOM mode: Select this mode when the center speaker is not connected. All center channel signals are redistributed to the left and right channel speakers.

3CH LOGIC mode: Select this mode when the surround speakers are not connected.

TO SELECT A DOLBY PRO LOGIC MODE

“1,2

1 Press the DOLBY PRO LOGIC button repeatedly to select tlhe appropriate mode.

When selecting the DOLBY PRCi LOGIC or 3CH LOGIC mode, the indicator lights up, and the selected mode name runs through on the display. Each time the button is pressed, the mode changes as shown below.

r DOLBY PRO LOGIC+F 3CH LOGIC DC)LBYPRO LOGIC oFF (cancel) 2

2 Press the DOLBY PRO LOGIC button again and hold it down until the center speaker m;de to be selected appears.

When selecting the DOLBY PRO LOGIC mode in step 1: Im

“NORMAL’,“WIDE and “PHANTOM”appear in turn.

When selecting the 3CH LOGIC Imode in step 1: “NORMAL!’and “WIDE appear one after another.

●Depending on the sound source or listening condition, surround effect may not be obtained even when the DC)LBY PRO LOGIC is on.

●The full DOLBY PRO LOGIC effect cannot be obtained when using the software without DOEE!ZZSS= mark. In this case, use the DSP surround system instead (see page 8).

●The DOLBY PRO LOGIC system is automatically canceled when the BBE or DSP system is turned on.

ENGLISH12