Troubleshooting
If you experience any of the following difficulties while using your player, use this troubleshooting guide to help you to remedy the problem. Should any problem persist, consult your nearest Aiwa dealer.
For trouble concerning operations while connected to your computer, also refer to “Troubleshooting” in the separate manual “Music Transfer pavit Edition.”
Operation| Symptom | Cause/Remedy | ||||
| There is no sound. | c The volume level is set to the minimum level. | ||||
|
|
| Increase the volume (page 12). | ||
|
|
| c The “pavit” is not inserted in the player correctly. | ||
|
|
| Reinsert the “pavit” and check if the “pavit” insertion indicator | ||
|
|
| “ |
| ” is displayed (page 11). |
|
|
|
| ||
|
|
| c The headphone plug is dirty. | ||
|
|
| Clean the headphone plug with a soft dry cloth. | ||
| The buttons do not work. | c The HOLD function is set to on. | ||||
|
|
| Release the HOLD function (page 21). | ||
|
|
| c The player contains moisture condensation. | ||
|
|
| Let your player sit for a few hours at room temperature. | ||
|
|
| c The battery is exhausted. | ||
|
|
| Replace the battery with a new one (page 7). | ||
The display becomes hard to | c The player contains moisture condensation. | ||||
see or nothing is displayed. | Let your player sit for a few hours at room temperature. | ||||
|
|
| c The battery is exhausted. | ||
|
|
| Replace the battery with a new one (page 7). | ||
| The volume will not | c The HOLD function is set to on. | ||||
| increase. | Release the HOLD function (page 21). | ||||
| The sound is distorted. | c The bit rate used when encoding the MP3 files was low. | ||||
|
|
| Send MP3 files encoded with higher bit rates to the “pavit.” | ||
| There is no sound output | c The headphone plug is not fully connected. | ||||
| from the right headphone. | Connect the headphone plug fully. | ||||
| Playback stops suddenly. | c The battery is exhausted. | ||||
|
|
| Replace the battery with a new one (page 7). | ||
| There is noise in the | c The music data itself contains noise. | ||||
| playback sound. | Noise may have been introduced when creating music data due to | ||||
|
|
| the conditions of the computer. Create the music data again. | ||
| Erroneous display. | c The player is not functioning normally. | ||||
|
|
| Remove the “pavit” from the player, and then press and hold | ||
|
|
| Nx/POWER for more than 10 seconds to reset the player. | ||
|
|
| c Send the music data to the “pavit” again, as the data stored in the | ||
|
|
| “pavit” may have been destructed. | ||
| The “pavit” insertion | c The “pavit” does not have any music data, or the music data stored | ||||
indicator becomes “ |
| ”. | in the “pavit” may be destructed. | ||
| |||||
|
|
| Send the music data to the “pavit” again. | ||
|
|
|
|
| (Continued) |
25