Aiwa CA-DW635 Care And Maintenance, Specifications, To clean the cabinet, Heads, Compact, section

CARE AND MAINTENANCE

SPECIFICATIONS

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the cabinet

Use a soft and dry cloth.

If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.

To clean the heads

When the tape heads are dirty;

-high frequency sound is not emitted

-the sound is not adequately high

-the sound is off-balance

-the tape cannot be erased

-the tape cannot be recorded on

FM tuner section

Tuning range

Antenna

AM tuner section Tuning range

Antenna

Cassette deck section Track format

Frequency response Recording system

Heads

87.5MHz to 108 MHz Rod antenna

530 kHz to 1710 kHz (1O kHz step)

531 kHz to 1602 kHz (9 kHz step) Ferrite bar antenna

4 tracks, 2 channels stereo Normal tape: 50 Hz – 12500 Hz AC bias

Deck 1: Recording/playback head x 1 Erasure head x 1

Deck 2: Playback head x 1

After every 10 hours of use, clean the tape heads with a head cleaning cassette.

Use separately sold dry-type or wet-type cleaning cassette. Refer to the instructions of the cleaning cassette for details.

Care of discs

. When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.

●After cdavina a disc, store the disc in its case. Do not leave the di’sc in ~aces that are hot or humid.

Care of tapes

●Store tapes in their cases after use.

●Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.

●Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

Compact		disc player	section
Laser			Semiconductor			laser	(k=	780 nm)
D-Aconverter			1 bit dual
General
Power output			5 W + 5 W (4 ohms,				EIAJ)
			FTC rule
			4 Watts per channel, Min.
			RMS at 4 ohms from 65 Hz to
			15,000 Hz, with no more than 1%
			distortion
output			PHONES (stereo minijack)
Power	requirements		DC 12 V using			eight	size	D (R20)
			batteries
			AC 120V,	60 Hz
Power	consumption		30 w
Dimensions of main unit (W x H x D)
			266 x 303x	278.5 mm
			(101/2 x12xll			in.)
Weight	of main unit		4.1 kg (9 Ibs.		1 OZ.)
Speaker
Type			120 mm cone		type
			27 mm ceramic			type
Dimensions (W x H x D)
			198 x 303x	232 mm
			(77/0 x12x	9 ‘/q in.)
Weight			1.75 kg (3 Ibs.			14 OZ.)	X	2
Impedance			4 ohms
Allowable		max. input	low

Specifications and external appearance are subject to change without notice.

COPYRIGHT

Please check the laws on copyright relating to recordings from discs, radio or external tapes for the country in which the machine is being used.

16 ENGLISH