Aiwa CSD-TD66, CSD-TD26, CSD-TD28, CSD-TD27 General, Sound Adjustment, Setting the Sleep Timer

GENERAL

SOUND ADJUSTMENT

Volume or tone adjustment does not affect recording.

VOLUME (VOL)

Press VOLUME N or M. The volume level is displayed as a number from 0 to MAX (25).

•The volume level is automatically set to 14 if the power is turned off when the volume level is set to 15 or more. (except when turning the power back on within 4 seconds)

•Pressing DISPLAY on the remote control displays the adjusted volume level (CSD-TD66 only).

3-MODE EQUALIZER

Press * 3-MODE EQUALIZER repeatedly until the desired mode is displayed.

The equalizer mode changes to R (Rock), P (Pop), J (Jazz) or no equalization, cyclically.

Rock - Emphasizes the high and low range of music. Pop - Emphasizes voice and midrange of music. Jazz - Emphasizes the low range of music.

* or EQ on the remote control (CSD-TD66 only)

T-BASS system

The T-BASS system enhances the realism of low- frequency sound.

Press T-BASS and the T-BASS indicator lights up.

QSOUND system

This system provides a rich, three dimensional sound area for stereo sources.

You can enjoy more enhanced sound.

Press QSOUND and the QSOUND indicator lights up.

•At higher volumes, turning QSOUND on may cause sound distortion. In this case, make the volume down.

Maintenance

To clean the cabinet

Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner.

To clean the heads

When the tape heads are dirty;

-high frequency sound is not emitted

-the sound is not adequately high

-the sound is off-balance

-the tape cannot be erased

-the tape cannot be recorded on

SETTING THE SLEEP TIMER

The unit can be turned off automatically at a specified time.

1 Keep REPEAT/SLEEP pressed until “30” flashes in the display.

2 Within 4 seconds, press r or tto specify the time until the power is turned off.

Each time it is pressed, the time changes between 10 and 90 minutes in 10-minute steps.

Specified time	While the sleep timer works,
	the dot keeps flashing.

To check the time remaining until the power is	En
turned off

Repeat step 1 shown above. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Display the remaining time and press r or t repeatedly until OFF is displayed.

NOTE

If the unit is turned off during tape playback, x on the deck will not be released. Press Z to release x.

After every 10 hours of use, clean the tape heads with a head cleaning cassette.

Use separately sold dry-type or wet-type cleaning cassette.

Refer to the instructions of the cleaning cassette for details.

Lens

To clean the lens

Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge.

ENGLISH 9