CD SYNC RECORDING
(from external CD or MD player.)
CD sync recording allows you to make an automatic digital recording from an external CD or MD player. During CD sync recording, the record deck starts in sync with the source, and tracks are added automatically.
3 | 1 |
| 3 |
| 1 |
| 2 |
1Press INPUT on the front panel or INPUT SEL on the remote control repeatedly until the desired input is displayed.
With each press of the button, the input changes as follows:
COAX (coaxial)
OPT 1 (optical on the front panel)
OPT 2 (optical on the rear panel)
ANALOG*
*CD sync recordings can not be made from an analog input.
2Load a blank or
3Press CD SYNC repeatedly on the front panel or remote control to select "1 TRK" or "ALL" .
To record only the first track from the source player, select "1 TRK".
To record the entire disc or tape, select "ALL".
4Play the source device.
Recording starts in sync with the source, and stops when there is no incoming signal for more than three seconds.
After the recording is finished, "BUSY" and "UPDATE" will be displayed briefly.
•If the source material is a CD, tracks will be added automatically to mirror the track structure of the original disc.
•Recording levels may not be adjusted during digital recordings.
When "DISC FULL" is displayed
There is not enough space on the disc, use another disc.
To stop the recording manually
Press son the record deck.
Alternatively, press
To play in other machines
As with all recorded
NOTE
You cannot start or resume recording from a halfway point.
•When in CD sync
•If you switch the source device from playback to pause during CD sync recording, this unit stops recording and runs the update process.
•It is possible to listen to the sound while recording by selecting the appropriate input on your receiver, preamp or processor.
En
ENGLISH 15
