Aiwa XP-R120 Inserting a disc → H, Signal sound function, To remove the disc →, Before Playback

G

DSL

H 1

2 3

I

USING ON AC HOUSE CURRENT

Use only an AC adaptor whose rated output is DC 5 – 6 V, 250 – 300 mA. Connect the AC adaptor in the same way as when recharging the batteries. During operation on AC house current, all of the battery indicator disappears.

BEFORE PLAYBACK

HOLD switch → F

Release the HOLD switch before playback. → a

When not using the unit, set the HOLD switch to the HOLD position. → b Accidentally pressed button will not function.

If buttons are pressed when the HOLD switch is set to the HOLD position, “HOLd” flashes in the display.

Turning on and off → F

Turning the power on

Press ePLAY/PAUSE. Power is turned on and playback starts.

Note

“Err” appears on the display when you play a disc placed upside-down or a defective disc.

Turning the power off

If no new operations are done within 30 seconds from the end of last operation, the power is turned off automatically. (Auto power off function)

•You can turn off the power by pressing sSTOP/OFF/CHARGE before it is automatically turned off.

Standby mode → F

When an operation finishes, the unit goes into standby mode until the auto power off function automatically turns off the power.

To enter standby mode, press ePLAY/PAUSE to start playback, then press sSTOP/OFF/CHARGE.

Adjusting the sound → G

Volume

Turn the VOL control to adjust the volume.

DSL

Press DSL repeatedly for more powerful sound and deeper bass. : Deep bass is emphasized.

: Deep bass is strongly emphasized. : Normal sound

Signal sound function

You can check the operation by beep sound when you press an operation button. The signal sound function is activated when you purchase this unit.

To cancel the signal sound function, press ePLAY/PAUSE while pressing

PLAY MODE to display “” while in stop mode. To resume the beep sound, repeat this procedure.

Inserting a disc → H

1Slide the OPEN switch to open the disc compartment.

2Place a disc in the center with the label side facing up.

3Close the disc compartment.

To remove the disc → I

Pick up the disc, holding its edge, while pressing the pivot gently.

Note

•The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-R/RW recorders because of differences in recording platforms.

•Do not attach any seal or label to either side (the recordable side or the labeled side) of a CD-R/RW disc. It may cause malfunction.