Connecting to a DVD Player

via HDMI

Please refer to your DVD player’s instruction book for additional information. Power off both the TV and the device before making any connections.

Note: Not all cables shown in the illustration are supplied.

If your DVD player has an HDMI socket, you can connect via HDMI for better video and audio quality.

When the connection is made, switch to YPbPr source. See, Input selection section.

You may also connect through the SCART input.

12V

1IM DH

DC IN

SPDIF

Coax.OUT

12V

1IM DH

DC IN

SPDIF

Coax.OUT

HDMI Cable (not supplied)

External device

Scart Cable (not supplied)

When you connect to DVD player as illustrated above, switch to the connected HDMI source. See, Input Selection section for more information on changing sources.

Connecting to a DVD Player

Some DVD players are connected through COMPONENT SOCKETS (YPbPr). YPbPr can be used only when you connect a device that has a YPbPr output through the PC input with YPbPr to PC cable (YPbPr cable is not supplied).

When the connection is made, switch to YPbPr source. See, “Input selection” section.

To enable audio connection, use the VGA/ Component Audio cable. First, plug single jack of the cable to the TV. Afterwards, insert your DVD player’s audio cable’s connectors into the plural part of the VGA/Component audio connection cable (see illustration below). Colours of the connected jacks should match ( RED & WHITE).

Audio Connection

To RED & WHITE inputs

AV

 

 

Side

 

 

Side AV Input

Audio Cable

DVD Player

Side AV

Connection cable

(Not supplied)

 

(supplied)

 

 

Video Connection

YPbPr to PC Scart socket cable (optional) HDMI inputs

DVD Player

External device

Note: These three methods of connection perform the same function but in different levels of quality. It is not necessary to connect by all three methods.

Remote Control Handset

Inserting Batteries

Remove the battery cover located on the back of the handset by gently pulling backwards from the indicated part.

Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover.

Note: Remove the batteries from the remote control handset when it is not to be used for a long period. Otherwise it can be damaged due to any leakage of batteries. Remote range is approximately 7m/23ft.

English - 53 -

Page 11
Image 11
Akai ALED2405T manual Connecting to a DVD Player Via Hdmi, Remote Control Handset, Inserting Batteries, External device