Alamo 5, 6 manual Motor Control

OPERATION

All operating positions of the mower are controlled with two control valve levers. The 'lift' function control permits selection of Up, Lock, or Down position and the 'tilt' control may be placed in one of four positions; Up, Lock, Down, or Float.

Moving the 'lift' lever up will raise the cutter bar. Release the lever and it will automatically return to the center position to lock the cutter bar into position. Moving the "lift" lever down will lower cutter bar.

Lift the 'tilt' lever and the cutter bar tip will arc up toward the operator. Push down on the tilt control lever and the tip of the cutter bar will rotate down. Release the lever and it will automatically return to center position to lock the cutter bar into position. By pushing the lever all the way down, it will lock into float detent position. This allows the cutter bar to follow the contour of the ground. The tilt function also incorporates an additional feature. If the tilt is lifted to its maximum position, the lift cylinder will engage and fully raise the cutter bar to maximum up position. When the tilt is lowered the bar will automatically return to the same lift height it was. This allows the operator to use one lever to raise the cutter bar to avoid an obstruction such as a utility pole.

If it is necessary to hold the cutter bar in the air (in such conditions as mowing over water, stones, or other debris) the operator should then set the height with the 'lift' control in the hold (center) position and the 'tilt' control in the hold (center) position. The valve incorporates holding components to maintain position.

7.1 MOTOR CONTROL

The motor starts when the button on the control stand is pulled out and tractor engine is running. The motor rotation can be reversed, to clear cutter bar, by moving the toggle switch, located above the motor switch, to the center position, allow the cutter bar to stop and then move the toggle to the other position.

7.2 KNIFE SPEED

Operate the tractor engine at the RPM that will produce 540 PTO RPM. This will produce the proper knife speed for the cutter bar.

Many varied objects, such as wire, cable, rope, or chains, can become entangled in the operating parts of the mower head. These items could then swing outside the housing at greater velocities than the blades. Such a situation is extremely hazardous and could result in serious injury or even death. Inspect the cutting area for such objects before mowing. Remove any like object from the site. Never allow the cutting blades to contact such items.

(SGM-06)

7.3 TRACTOR MOWING SPEED

The best mowing speeds are usually between 1-3 MPH. Conditions will vary with the material being cut and the terrain, but select a speed producing the desired result and maintain that speed. If too much material falls on the cutter bar, increase the ground speed slightly. If grass is being torn out, slow down by switching to a slower gear to allow the knife time to cut clean. If the cutter bar breaks back frequently when cutting heavy dead grass, brush, or vines, slow down to allow the knife time to cut cleanly.

SB5/6 03/09 Operation Section 3-17

© 2009 Alamo Group Inc.

OPERATION