MAINTENANCE
Before installing the spindle (with the bearing pressed on it), lubricate the rubber portion of the seal. This will reduce the chance of the Seal being torn by the installation of the spindle and is a necessary step when setting the rolling Torque.
Turn the Spindle Housing Upside Down and insert the spindle (with the bearing pressed onto it) into the spindle housing until the bearing cone contacts the cup in the Housing. During this step take care not to damage the seal.
While supporting the Spindle and Housing turn the assembly over so that the assembly is setting on the spindle.
Install the upper bearing (4) on the spindle shaft (1).
After the Upper Bearing is installed, install the nut (5) with the chamfer facing up. Run the nut down against the bearing, but do not torque the nut at this time. Clamp the spindle Housing in a vise so that the spindle shaft can rotate. Tighten the nut until the spindle shaft has a rolling torque of 25
Install the tanged lockwasher (6) with the outside prongs facing upward.
Install the top nut (5) with the chamfer facing down. Block the spindle to keep it from rotating and torque the top nut to a minimum of 100
Install vent plug (8) and Grease Fitting (9).
Fill spindle assembly with NLGI EP#2 Grease (Approx 22 oz.).
SAMURAI 12/08 | Maintenance Section |
©2008 Alamo Group Inc.
