MAINTENANCE
MAINTENANCE
START UP PROCEDURE
1.Read all safety instructions. Decals on the Samurai Boom warn you of particular and multiple hazards. Many decals are attached close to part of the Samurai Boom where there is a possible hazard. Read and make sure you understand the safety messages before you operate the Samurai Boom. Keep all decals clean and readable. Replace lost or damaged decals.
2.Before operating, read all the safety and operating instructions in the Operators Manual for both the tractor and mower.
3.When the hydraulic tank has been filled and the mower unit properly assembled, the unit should be started up. NOTE: Make sure that no materials, tools, or jacks, have been left under the mower head. Make sure the front and rear of the mower are properly guarded to prevent any foreign objects from being thrown by the mower. All other workers should be kept a safe distance from the unit before the mower is started.
4.Start the tractor and idle at a slow engine speed until oil is being pumped.
5.Engage the Cutter Control Valve at low engine rpm and run the mower slowly for a short period until all air is removed from the hoses. Keep all persons WELL CLEAR of mower since Blades can THROW OBJECTS with great velocity for a considerable distance! KEEP CLEAR!
6.With the area clear of any ground and overhead obstructions, work each cylinder on the boom one at a time, several times, to expel any air in the Hoses and Cylinders.
7.Run the Mower Head for 5 minutes. While the tractor is idling, blocked, wearing protective clothing and eye protection, CAREFULLY check for leaking hydraulic fittings, hoses and ports at this point with a piece of cardboard, DO NOT USE YOUR HAND! If any are found stop the tractor immediately and correct any leaky connections.
8.Check the fluid level in the Hydraulic Tank on the Tractor, and add oil if required. As the air has been forced out of the Cylinders and Hoses, it goes into the Hydraulic Tank and reduces the oil level. Check your Tractors Operators Manual for the proper level and type of oil to be used.
SAMURAI 12/08 | Maintenance Section |
©2008 Alamo Group Inc.
