(SG-34)

OPERATION

5.CONNECTING ATTACHING HEADS TO THE BOOM

1.Start by using a hoist to lower the boom(1) down to the Machete head(2). Align the Boom with the Machete Head Hitch Post(3), insert the upper hitch pin(4) through the Dipper end of the boom and the Machete Head Upper Hitch Post. Attach with washer(5), nut(6) , and cotter pin(13).

2.Then align the lower linkage(7) of the Boom and insert the lower hitch pin(8) throught hitch post. Attach with nut(9) and bolt(10).

3.Finally make sure all bolts, nuts, and pins are tightened to recommended torque. OPS-B- 0004

5.1Connecting Mower Head Hydraulics

1.Follow hydraulic connections according to the Hydraulic Connection Decal on boom. Attach the Mower Hydraulics to the Boom and the Motor according to the colors specified on decal. Then attach the door cylinder hoses from the boom to the Machete Heads Door Cylinder according to the colors specified on decal.

2.When connecting the mower head hydraulic lines to the boom, keep the hose, quick couplers, and swivels free of dirt and other contaminants. Wipe all dirt and other contaminants from the hydraulic remote ports and mower hydraulic hose coupler with a clean cloth before connecting.

NOTE: The Buzzbar and the Flail Axe are attached in the same fashion as the Machete Head, however the Flail-Axe does not have Auxilary/Door Connections(Yellow/Yellow and White Hoses) keep these sealed off. OPS-B- 0019_D

Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and hose connections. Relieve hydraulic pressure before performing maintenance or repairs. Use gloves and eye protection when servicing hot components. Contact with a hot surface or fluid can cause serious injury from burns or scalding.

SAMURAI 12/08

Operation Section 3-9

©2008 Alamo Group Inc.

OPERATION

Page 57
Image 57
Alamo FC-0002 manual Connecting Attaching Heads to the Boom, Connecting Mower Head Hydraulics