MAINTENANCE

MAINTENANCE

Gearbox Oil Level

The Gearboxes have been filled with lubricant to the proper dipstick level prior to shipment. However, you should check the oil level dipstick before operating, and frequently thereafter. To check for accurate oil level on gearbox, run the cutter for a couple of minutes to allow the gearbox to warm up to at least 70° or 75° and allow the oil to run into the dipstick reservoir. This allows for proper oil level to be checked. Correct oil level should be between the two grooves on dipstick. Never fill gearbox with to much oil, damage to gearbox seals can occur. Refer to figure below for correct oil level.

NOTE: Overfilling the Gearbox will cause pressure to build up and cause Oil Seals to leak.

ATTENTION: If the Gearbox suddenly starts making an unusual noise, stop at once, check for leaks, and refill Gearbox as required.

Recommended lubricant is Multi-Purpose Gear Oil (P/N 00786250). Center box capacity is 2-1/2 Quarts.

FX17/FX21 02/11

Maintenance Section 5-4

© 2011 Alamo Group Inc.

Page 144
Image 144
Alamo FX17, FX21 manual Gearbox Oil Level