Alamo FX17, FX21 manual RollerScraper Assembly Instruction Sheet Part No W

ASSEMBLY

ASSEMBLY

RollerScraper Assembly Instruction Sheet - Part No. 5057W

1.Place the tractor and mower on a level surface, and completely lower the mower to the ground.

2.Working with one head at a time, place a jack under the cutter housing and raise the head such that the roller is slightly elevated from the ground.

3.Remove and discard the four carriage bolts that retain the two roller brackets. (See ASM-FL-0020.) These are the same bolts that would be removed to adjust the height.

4.Attach the two scraper brackets as shown in ASM-FL-0021. Use four of the new ½ x 2 in. carriage bolts supplied with the kit since these are longer to accommodate the thickness of the brackets.

5.Attach the scraper to the brackets as shown in Figure 2 using four ½ x 1-1/2 in. carriage bolts, washers, and nuts supplied with the kit.

6.Repeat this process for each head.

7.Verify that all bolts have been tightened.

FX17/FX21 02/11 Assembly Section 3-6

© 2011 Alamo Group Inc.