OPERATION
OPERATION
13.Placing Boom Arm on Boom Arm Rest
Before transporting tractor between locations, idle the tractor engine, disengage the attached head, and wait for all head motion to come to a complete stop. Place the boom in its storage cradle rest support and then turn the joystick master switch to the OFF position.
•Placing Boom Articulating Arm on Boom Arm Rest
•Extend the dipper section approximately half way out.
•Bring the Lift to its full height and carefully swing the boom back until it is just positioned over the Boom Rest. NOTE: There is a formed “V” plate on the boom arm that fits onto the boom arm rest.
•Lower the boom arm until this “V” rests on the Boom Rest.
•Place the Master Switch in to the OFF position. The boom is now in the transport position. To remove the boom from the Boom Rest, pull the Lift back and raise the boom about 6 inches. Then Swing the boom around to the desired position.
Never allow children or other persons to ride on the Tractor or Implement.
Falling off can result in serious injury or death.
Before transporting the tractor on a public roadway or boarding a trailer for transport, the tractor brake pedals should be locked together. Locking the pedals ensures that both wheels brake simultaneously while stopping, especially when making an emergency stop.
Use extreme caution and avoid hard applications of the tractor brakes when towing heavy loads at road speeds. Never tow the implement at speeds greater than 20 MPH (25 kph).
AXTREME 2 02/10 | Operation Section |
© 2010 Alamo Group
