Mainboard KI51PV-754

Hot Key Power ON

This option allows you to use the Ctrl key along with a hot key (function key) to power on your system. This option is configurable only when “Power-On Function” is set to “Hot Key”.

Options: Ctrl-F1 (Default), Ctrl-F2, ……, Ctrl-F12.

Onboard FDC Controller

Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”. Options: Enabled (Default), Disabled.

Onboard Serial Port 1

Select an address and corresponding interrupt for the first/ second serial port.

Options: Disabled (Default for port1), 3F8/IRQ4, 2F8/IRQ3 (Default for port2), 3E8/IRQ4, 2E8/IRQ3, Auto.

Onboard Parallel Port

Select an address and corresponding interrupt for the onboard parallel port. Options: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled (Default).

Parallel Port Mode

This option allows you to select a parallel port mode for the onboard parallel port.

Options: SPP

Standard Printer Port.

EPP

Enhanced Parallel Port.

ECP(Default)

Extended Capabilities Port.

ECP+EPP

ECP & EPP mode.

Normal

 

EPP Mode Select

Select EPP port type 1.7 or 1.9. This field is only configurable if “Parallel Port Mode” is set to “EPP” or “ECP+EPP”. Options: EPP 1.9(Default), EPP 1.7.

ECP Mode Use DMA

Select a DMA Channel for the parallel port when using the ECP mode. This option is only configurable if “Parallel Port Mode” is set to “ECP”. Options: 3 (Default), 1.

PWRON After PWR-Fail

This option will determine whether your system will boot after restoring power after a power failure. If you select “On”, the system will boot whether or not the system was on before power failure. If you select “Former-Sts”, the system will be restored to the status before the power failure. Options: Off (Default), On, Former-Sts.

31