Alcatel-Lucent 740 manual Interface name slot/port

Starting the OmniAccess 740

Step 7: Establish authentication for new users by configuring new user accounts. To configure a new user account, use the following command:

username <user-name>{password [5] <password>nopasswordsecret [5] <password>}

Example:

ALU(config)# username user1 password pass1

Step 8: Configuring an interface. Enter the following command to enter the Interface Configuration mode.

interface <name> <slot/port>

Example:

ALU(config)# interface GigabitEthernet 7/0

ALU(config-interfaceGigabitEthernet7/0)#

(For more information on configuring interfaces, refer to the ‘The Command Line Interface’ chapter in the OmniAccess 700 CLI Configuration Guide.)

Step 9: Administratively bring up the interface by using the ‘no shutdown’ command:

Example:

ALU(config-if GigabitEthernet7/0)# no shutdown

Step 10: Configure an IP address for the interface by entering the following command. Enter the IP address in the valid IP address format A.B.C.D.

ip address {<ip-address subnet-mask><ip-address/prefix- length>}

Example:

ALU(config-if GigabitEthernet7/0)# ip address 192.168.1.1/24

Note: In the above example, 192.168.1.1 is assumed to be the GigE 7/0 LAN facing interface and IP address. You can configure the IP address based on your topology.

Step 11: Enable SSH and Telnet for in-band Management. The following command enables SSH/Telnet connection to a remote computer:

•Secure Shell (ssh) is a program for logging in to a remote machine that provides secure communication between two systems.

ssh {enabledisable}

Example:

ALU(config)# ssh enable

•Telnet is a user command and an underlying TCP/IP protocol for accessing remote computers. Telnet is a program that enables connection to foreign or remote host computers, and provides access to information on them.

telnet {enabledisable}

Example:

ALU(config)# telnet enable

Alcatel-Lucent

48 OmniAccess 740 Hardware User’s Guide