Command Line Interface
4-144
Example
To set the timeout to two minutes, enter this command:
exec-timeoutThis command sets the interval that the system waits until user input is detected.
Use the no form to restore the default.
Syntax
exec-timeout [seconds]
no exec-timeout
seconds - Integer that specifies the number of seconds.
(Range:0 - 65535 seconds; 0: no timeout)
Default Setting
CLI: No timeout
Telnet: 10 minutes
Command Mode
Line Configuration
Command Usage
• If user input is detected within the timeout interval, the session is kept open;
otherwise the session is terminated.
• This command applies to both the local console and Telnet connections.
• The timeout for Telnet cannot be disabled.
Example
To set the timeout to two minutes, enter this command:
password-threshThis command sets the password intrusion threshold which lim its the number of
failed logon attempts. Use the no form to remove the threshold value.
Syntax
password-thresh [threshold]
no password-thresh
threshold - The number of allowed password attempts.
(Range:1-120; 0: no threshold)
Default Setting
The default value is three attempts.
Console(config-line)#timeout login response 120
Console(config-line)#
Console(config-line)#exec-timeout 120
Console(config-line)#