Tape in jacks | Alesis 12R specification

Connections

TAPE IN jacks

The [TAPE IN] jacks on the rear panel are designed for playback of a stereo tape deck (or any other -10 dBV level signal) through the [MONITOR OUT] and [PHONES] jacks only. A signal at the [TAPE IN] jacks cannot be heard from the [MAIN OUT] jacks.

This allows you to use the Multimix 12R to monitor a mixdown to a 2- track deck through your headphones. (If you plugged your mixdown deck into the line inputs on the channels, it would cause feedback when you press “record”.) By placing the [PHONES/MONITOR] switch in the TAPE position, you will hear the mixer's output after it has been passed through the mixdown deck, so you can make sure that it is recording correctly.

•Another use for the [TAPE IN] jacks is to play a CD or tape into a PA system, automatically turning off all the microphones into the main PA system when the front panel MSTR/TAPE switch is set to the TAPE position. Note that in this application, the PA system must be fed from the MONITOR OUT instead of the MAIN OUT jacks, and will be affected by the level of the [PHONES/MONITOR] control as well as by the [MASTER] control fader.

Image 22

Alesis 12R manual Tape in jacks

Contents

Reference Manual Page Important Safety Instructions Page Page Page Page Page CE Declaration Of Conformity Front Panel Table of Contents Dimensional Drawing Applications Alesis Multimix 12R Microphone Preamplifier/Mixer Using this manualIntroduction Conventions Grounding Instructions AC power InstallationUnpacking Power switch Use clean powerMounting Inputs ConnectionsCable common sense Microphone Inputs Phantom power Line-level devices synthesizers, CD players, video Phantom Power will not be Used Tape in jacks Phonograph turntables Effects via Aux Send and Aux Return How to connect effect devices and signal processorsAbout stereo effect devices Using Aux 1 as an effects send Connecting an in-line processor Connections To a mono system OutputsTo a stereo PA system or instrument amplifier To a stage monitor foldback system To another mixer To a stereo tape recorder To an Adat multitrack recorder In-line Adat recording Using two Multimix 12Rs for more flexibility Connections Phones Monitor Out Connections Operating Instructions Before turning the mixer on, zero out the controls Setting input trim levels Peak LED method Metering/Unity Gain method Trim gain ranges Typical Fader and Control LevelsUnity gain points Aux Send levels Proper gain staging of other equipment How to Set Aux Send and Return Levels AUX System Effects Send/ReceivePage Using the meter Output distortion Avoiding noise System noise ground loops, hum, induced noise ① to Eliminate HUM if the Above has Failed Page Operating Instructions Multitrack recording ApplicationsTracking/Overdubbing Mixdown Using the High and LOW EQ controls Monitoring AUX 1 in the Phones jack Troubleshooting Troubleshooting IndexPage Exterior cleaning Maintenance/ServiceRefer All Servicing to Qualified Technicians Connectors SpecificationsFrequency Response Levels Impedance Noise performance typical PowerDistortion THD+N Dimensional Drawing Block Diagram Level diagram Index Tape Warranty / Contact Alesis Contact Information