10
PRIVATE NUMBER
or
TALK 1:32:56
UNKNOWN NUMBER
Call with Caller ID (number and name or an associated number in the Phone book):
TALK 1:32:56
SOMEBODY
Calls with blocked name in Caller ID is shown as:
TALK 1:32:56
PRIVATE NAME
or
TALK 1:32:56
UNKNOWN NAME
The number ‘1:32:56’ represents the elapsed time of your call, in hours, minutes and seconds.
Key entries during a call will replace the number/name in the second line, and the digits are left-truncated in
case the entered number exceeds 16 digits.
Display presentation after call is terminated
When the call is terminated, the current screen is maintained for 5 seconds before the phone returns to idle
presentation. This current display is interrupted in the event of a key press or an incoming call.
Making Calls
Making Calls – Pre-Dialing
You can enter the phone number before pressing Talk/End to get a dial tone:
1. Enter the number. It will be displayed on the second line. In case the number exceeds 16 digits, it
continues in the third line. You may enter a 3-second pause in the sequence by pressing REDIAL. It is
indicated by the character "P". The number can be a maximum of 24 digits, including pauses.
1234567890123P96
322300
2. Check if the number is correct. You can backspace by pressing CLEAR. The entire number is cleared by
holding down CLEAR.
3. Press Talk/End to dial the displayed number.
TALK 0:00:01
7890123P96322300
Making Calls – Post-Dialing
1. Press Talk/End, and listen for dial tone. The Call Timer starts running and ‘EXTERNAL CALL’ is
shown in the display:
TALK 0:00:01
EXTERNAL CALL
2. Enter the phone number, which replaces the ‘EXTERNAL CALL’ in the display:
TALK 0:00:02
9876543210
The display shows the digits of the number as they are entered. The first digit is entered in the left-hand side of
the second line.
Ending your outgoing call
Your outgoing call is terminated by either pressing:
●Talk/End;
●or by placing the Handset in the charger.
After terminating your call, the Call Timer stops running, and ‘ENDED’ is shown in the first line of the