8
6 Snap the bracket into place on the back of the Base. If you are using the tabletop bracket, run the two
cords through the channel at the back of the bracket. If you are wall mounting the Base, carefully line
up the slots on the wall mount bracket with the studs on the telephone wall plate, and carefully mount
the telephone on the wall.
7 Connect the power supply to a live outlet. Make sure the outlet is not controlled by a switch. DO NOT
connect the telephone line cord to the phone jack until the Handset is fully charged.
8 Plug the adaptor in socket-outlet which is near equipment and easily accessible.
9 Place the Handset in the Base cradle. The Handset and Base communicate with each other
automatically. This is the Registration process, and it may take up to 60 seconds.
10 Allow the Handset to charge for a day for the first time charging. The CHARGE indicator on the
Base will glow
while the Handset is charging.
Basic Operation
With the Handset idle (on hook), and the battery pack having at least a minimum charge, it will display:
READY
When you name your Handset (see Handset Naming), it will replace ‘READY’.
Answering Calls
If auto answer is disabled, press Talk/End, or any numerical key (0 to 9), or * or # .
If auto answer is enabled, the incoming call is answered by removing the Handset from the charger. If the
Handset is not cradled, simply press Talk/End, 0 – 9, * or #.
You can end your call by pressing:
Talk/End, or
●Place the Handset in the charger
Display presentation for incoming calls:
An incoming call without caller ID:
EXTERNAL CALL
If your local service provider sends the caller ID information, it is shown in the display instead of ‘external