Operating Instructions
Programming
1.Set DIP switch #8 to the ON position.
2.Select the desired program number to change. The LED should be flashing.
3.Select DRY TIME. Set the time with the Up/ Down arrows.
4.Select COOL TIME. Set the time with the Up/ Down arrows.
5.Select TEMPERATURE. Set the temperature with the Up/Down arrows.
6.Press and hold the Program Select button about 3 seconds until the LED stops flashing. The selected program number is now programmed. If the Program button is pressed for less than
3 seconds, the controller will cancel the program and display the next program’s settings. If not programmed correctly, the display will flash “E2F” for 4 seconds, and the default settings will be used. Follow steps 4 through 7 to reprogram any program number. When finished, set DIP switch #8 to OFF. The programs are now stored.
7.During the Program Mode, if the Up/Down arrows or Display button is not pressed within 10 seconds, the default program settings will be used.
8.Temporary Reprogramming of Current Programs (OPL ONLY)
9.The Drying Time, Cooling Time and Temperature of a program currently in use may be modified simply by adjusting any or all of the program parameters for that program, as needed. Once a modification has been made, the current program LED will flash indicating that it has been modified.
10.Use the Up/Down arrows to adjust program time.
11.Use the Display Select button to choose between Drying Time, Cooling Time, and Temperature. Then use the Up/Down arrows to adjust the times and temperature.
12.To cancel this temporary programming mode push the STOP button once to stop the current cycle and once more to cancel the modified program settings. The program will revert back to its original settings.
Rotation Sensor
The rotation sensor must “read” the key on the basket shaft or pulley. The sensor must be set approximately 1/4 inch from the key or pulley. Look for the light on the sensor to come on as the key passes the sensor; this is a correctly operating sensor. If no light appears, either the sensor is out of range or the key/pulley or the sensor is bad. In addition, if the light stays on continuously, then the sensor is too close to the component or the sensor is bad.
Safety
At the end of the cool down cycle, the tumbler will stop and display “END.” The DMP control will automatically rotate the basket for 5 seconds every 2 minutes for a total of 20 minutes, until some function of the tumbler is activated/deactivated by the user.
Operational Check for the Board Diagnostics
1.“dor” indicates that the loading or lint door is open.
2.Cycle the tumbler to check if the buzzer activates.
3.
4.“bbt” indicates a broken belt condition or a faulty rotation sensor. (Only available on tumblers with the rotation sensor.)
5.Hold the START button to display the drum RPM’s; the display will read “r##” where ## are the RPM’s. (Only available on tumblers with the rotation sensor.)
18 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 70400001 |