Programming
Temperature Controlled Fill
17.Display shows temperature in degrees F or C. Display will show degrees F if configured for “FAr” in SETUP Mode, or degrees C if configured for “CEL” in SETUP Mode. Range is 75°F to 200°F, or 00F (no heat for segment), or 25°C to 93°C, or 00C (no heat for segment).
18.Press the ∧ keypad to increase, or ∨ keypad to decrease temperature in
The control will energize heat and pause cycle timing for up to 40 minutes until the programmed temperature is first reached.
NOTE: If temperature not reached after 40 minutes, control resumes cycle.
After cycle resumes, control will attempt to maintain programmed temperature if it senses water in the machine.
19.If display shows “drAI”/“nodr” during segment programming, a drain step option can be selected. Select “drAI” for a drain step followed by an optional spin. Select “nodr” for no drain step.
NOTE: The machine will proceed directly to the next segment if “nodr”.
20.Change the selection by pressing the ∧ or ∨ keypad.
21.Press START to continue.
22.If “drAI” is selected (or if your model does not
provide the option of selecting “drAI”/“nodr”), the display will show “SPIn” one second, “tInE” one second, and then the time for spin: “00” (no spin) or
23.Change the selection by pressing the ∧ or ∨ keypad.
24.Press START to continue.
NOTE: Programming a time other than “00” for this step will make the RINSE indicator LED light while this step is running, but not in PROGRAM Mode.
25.The main display shows “rIN1” indicating you are in the Rinse segment (number will represent Rinse cycle selected
26.Press START keypad. Display shows the time for agitation during the step: “00” (skips segment) or
NOTE: This is the time after the fill and before the drain and does not include spin time.
27.Press the ∧ or ∨ keypad to alter the selection.
28.Press the START keypad to continue.
29.Display shows “CFIL”, “HFIL”, “bFIL” (for cold, hot, warm [both]) or “AFIL”.
30.Press the ∧ or ∨ keypad to alter the selection.
31.Press the START keypad to continue.
NOTE: Auxiliary Fill (“AFIL”) possible only if configured for “AFIL” in SETUP Mode. If configured, auxiliary fills can be programmed to low, medium, or high water level in cycle step.
32.Display shows “LO”, “nEd”, or “HI” for low, medium, or high water level, respectively.
33.Press the ∧ or ∨ keypad to alter the selection.
34.Press the START keypad to continue.
35.Display shows “SUP0”, “SUP1”, “SUP2”, “SUP3”, “SUP4”, “SUP5”, “SUP6” or “SUP7”. Refer to Table 3 for operation of each supply selection.
36.Press the ∧ or ∨ keypad to alter the selection.
37.Press the START keypad to continue.
NOTE: “SUP5” and “SUP6” appear ONLY if control is configured for “SUP5” in SETUP Mode. If the alternate function is selected (“AFIL”), the output will function as an additional fill valve signal with a programmable water level. In this case, the extra supply function would NOT be available.
NOTE: If programmed for “SUP2”, the ADD BLEACH indicator LED light turns on and the buzzer sounds, if programmed, while supply 2 is on.
14 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232224 |