The leftmost supply compartment (as seen from front of machine), which can be used for detergent, flushes during fill cycles whether Supply 1 option is enabled or disabled. When Supply 1 option is enabled, Supply 1 (S1) output energizes and is available for external chemical supply if desired. The Supply 2 option controls the middle compartment, which can be used for bleach. Supply 3 and Supply 7 options control the rightmost compartment, which can be used for fabric softener. Supply 4, Supply 5, and Supply 6 options control external chemical supplies, as desired. Refer to Table 3 for operation of each supply selection.

NOTE: For additional assistance, refer to installation instructions.

Temperature Controlled Fill

38.Display shows temperature in degrees F or C. Display will show degrees F if configured for “FAr” in SETUP Mode, or degrees C if configured for “CEL” in SETUP Mode. Range is 75°F to 200°F, or 00F (no heat for segment), or 25°C to 93°C, or 00C (no heat for segment).

39.Press the ∧ keypad to increase, or ∨ keypad to decrease temperature. Temperature changes in one-degree increments.

The control will energize heat and pause cycle timing for up to 40 minutes until the programmed temperature is first reached.

NOTE: If temperature is not reached after 40 minutes, control resumes cycle.

After cycle resumes, control will attempt to maintain programmed temperature if it senses water in the machine.

40.If display shows “drAI”/“nodr” during segment programming, a drain step option can be selected.

41.Select “drAI” for a drain step followed by an optional spin. Select “nodr” for no drain step.

NOTE: The machine will proceed directly to the next segment if “nodr”.

42.Change the selection by pressing the ∧ or ∨ keypad.

43.Press START to continue.

44.If “drAI” is selected (or if your model does not

provide the option of selecting “drAI”/“nodr”), the display will show “SPIn” one second, “tInE” one second, and then the time for spin:

“00” (no spin) for 60-240 seconds IF you are in Rinse 1 – 5.

Programming

45.If you are in Rinse 6, the time for spin will show 0 or 1-10 minutes.

46.Change the selection by pressing the ∧ or ∨ keypad.

47.Press START to continue.

IMPORTANT: The spin time in Rinse 6 is programmed in minutes (0-10 minutes, in one-minute increments). (Rinse 6 segment should be used as the final rinse, even where there may be fewer than four rinses. Program zero time for preceding rinses you wish to exclude.)

48.Display shows temperature.

49.Exit PROGRAM Mode by moving the Program/ Run switch back to the right as seen from the front of the machine.

NOTE: The SPIN indicator LED will automatically light during the wash cycle when the last spin programmed in a cycle is operating (regardless of which segment).

F232224

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

15