Installation
Before You Start
Tools
For most installations, the basic tools you will need are:
2
1
3
NOTE: For more detailed information, refer to Section on Dryer Exhaust Requirements.
Electrical
●ELECTRIC DRYER
Dryer needs a 3 or 4 wire 120/240 or 120/208 Volt, 30 Amp, 60 Hertz, 1 phase electrical supply.
●GAS DRYER
Dryer needs a 120 Volt, 15 Amp, 60 Hertz, polarized
NOTE: For more detailed information, refer to Section on Electrical Requirements.
5
1Wrench
2Screwdrivers
3Level
4Teflon Tape
5Duct Tape
4
D818I
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent and is to be replaced by a qualified service person.
Gas
Dryer is equipped for Natural Gas with a 3/8 inch NPT gas supply connection. For more detailed information, refer to Section on Gas Requirements.
Location
Place the dryer on a solid floor with an adequate air supply. For more detailed information, refer to Section on Location Requirements.
Figure 1
Exhaust
Use rigid metal duct and exhaust the dryer to the outside by the shortest route possible.
D314I
Figure 2
WARNING
Any disassembly requiring the use of tools must be performed by a suitably qualified service person.
W299
8 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 510963 |