Installing the Dryer

Step 1: Position and Level the Dryer

For further assistance refer to Section on Location Requirements.

Install dryer before washer. This allows room for attaching exhaust duct.

Place the dryer in position, and adjust the legs until the dryer is level from side to side and front to back.

2

1

3

D259I

D669I

D699I

1Dryer Base

2Level

3Leveling Leg

Figure 3

Installation

●DO NOT use plastic or thin foil ducting.

●Locate dryer so exhaust duct is as short as possible.

●Be certain old ducts are cleaned before installing your new dryer.

●Use 4 inch (102 mm) diameter rigid or flexible metal duct.

●The male end of each section of duct must point away from the dryer.

●Use as few elbows as possible.

●Use duct tape or pop-rivets on all duct joints.

●Ductwork that runs through unheated areas must be insulated to help reduce condensation and lint build-up on pipe walls.

●Failure to exhaust dryer properly will void warranty.

Step 2: Connect Dryer Exhaust System

For further assistance refer to Sections on Location Requirements and Dryer Exhaust Requirements.

DODON’T

Figure 4

DRY1915N

DRY1915N

WARNING

A clothes dryer produces combustible lint. To reduce the risk of fire and combustion gas accumulation the dryer MUST be exhausted to the outdoors.

W116

NOTE: Venting materials are not supplied with the dryer (obtain locally).

510963

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9