Alliance Laundry Systems Dishwasher manual

NOTE: Use of the dispenser drawer or unit doors as a handle in the transportation of the unit may cause damage to the dispenser or doors.

Place unit in position on a solid, sturdy and level floor. Installing the unit on any type of carpeting, soft tile, a platform or other weakly supported structures is not recommended.

Place a level on the cabinet top and check if the unit is level from side to side and front to back.

NOTE: Level must rest on raised portion of top panel. Refer to Figure 3.

	1
5
4
3
	2
	SWD833N
1	Level
2	Rubber Foot
3	Leveling Leg
4	Locknut
5	Unit Base

Figure 3

If unit is not level, tilt unit to access the front and rear leveling legs. For easier access to leveling legs, prop up unit with a wooden block. Refer to Figure 4.

Loosen the locknuts and adjust legs by screwing into or out of unit base.

1

SWD832N

1Wood Block

Figure 4

Make sure that the unit does not rock. When unit is level and does not rock, tighten locknuts securely against bottom of unit base. If these locknuts are not tight, unit will move out of position during operation.

Leveling legs can be adjusted from inside the unit with a 7/8 inch deep well socket. All four legs must rest firmly on the floor so the weight of the unit is evenly distributed. The unit must not rock and must be level from side-to-side and front-to-back.

NOTE: Do not slide unit across floor once the leveling legs have been extended. Legs and base could become damaged.

Place rubber feet (supplied in accessories bag) on all four leveling legs. Refer to Figure 3.

Verify that unit does not rock.

6 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 802715