Step 4: Connect Drain Hose to Drain Receptacle
Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp and by removing the shipping tape.
Install the drain hose into the drain receptacle (standpipe, wall or laundry tub) following the instructions below.
IMPORTANT: Drain receptacle must be capable of handling a minimum of
Standpipe Installation:
Place the drain hose into the standpipe.
Remove the beaded strap from accessories bag and place around standpipe and drain hose and tighten strap to hold hose to standpipe. Refer to Figure 8. This will prevent the drain hose from dislodging from drain receptacle during use.
1 |
|
|
24 in. to 36 in. |
|
|
(61 to 91.44 cm) |
| |
Recommended |
|
|
Height |
|
|
| 2 |
|
| 3 | SWD598N |
|
| SWD598N |
1 | Drain Hose |
|
2 | Beaded |
|
3 | Standpipe 2 in. (5.08 cm) or |
Figure 8
Wall Installation:
For installations of this type, the drain hose MUST be secured to one of the fill hoses using the beaded strap from accessories bag. Refer to Figure 9.
NOTE: End of drain hose must not be below 24 in. (61 cm).
1
2
3
H023I
1Drain Hose
2Beaded Strap (tape if necessary)
3Fill Hoses
Figure 9
Laundry Tub Installation:
For this type of installation, the drain hose MUST be secured to the stationary tub to prevent hose from dislodging during use. Refer to Figure 10. Use the beaded strap (supplied in accessories bag) to secure hose.
1
2
SWD600N
SWD600N
1Drain Hose
2
Figure 10
802715 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 9 |