Step 8: (Washer Only) Remove the Shock Sleeves and Shipping Brace
Remove front access panel by removing the two screws at the bottom of the panel.
Remove the five bolts and lockwashers from shipping brace with 9/16 inch wrench and remove brace. Refer to Figure 22. One is holding the brace to the weight.
Remove this bolt first. Four bolts are located on the unit base. Remove the two front bolts next and then the two rear bolts. Remove all four shock sleeves by pulling on the yellow rope. Refer to Figure 22.
Remove the brace from the machine with shock sleeves and label attached to it.
IMPORTANT: The shipping brace, bolts, lockwashers and shock sleeves should be saved and MUST be reinstalled whenever the unit is moved more than 4 ft. (1.22 m). Do not lift or transport unit from front or without shipping materials installed. Refer to the Washer User’s Guide for proper instructions on reinstalling the shipping materials.
Store the shipping materials in the accessories bag. Save materials for use whenever the unit is moved.
On older models, remove label from front side of front access panel and place on back side of front access panel for future reference.
1 |
|
| 2 |
| 3 |
| FLW2124N |
| 4 |
| FLW2124N |
1 | Shock Sleeves |
2 | Motor Mount |
3 | Hooked End of Shipping Brace |
4 | Bolts and Lockwashers |
Figure 22
Reinstall front access panel.
IMPORTANT: DO NOT tip washer more than
6 inches (152.4 mm) in any direction after shipping brace has been removed. Shock absorbers may separate and damage to unit may result. For leveling purposes, the unit may be tilted a maximum of 6 inches (152.4 mm) in any direction.
Step 9: Wipe Out Inside of Washer Drum and Dryer Drum
Before using the washer and dryer for the first time, use an
SWD834N |
Figure 23
SWD603N
Figure 24
18 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 802715 |
