Vending
Meter Case
(Metered Models)
The factory mounted coin meter case does not include the service door lock, coin drawer, coin drawer lock and keys. These parts must be ordered (at extra cost) according to the purchaser’s requirements direct from the manufacturer of your choice.
NOTE: On models with standard capacity meter case and high capacity meter case models starting with Serial Nos. beginning 1010, you have the option of using a screw type lock or a 1/4 turn lock on the meter case service door. If you choose to use a screw lock, then the special bracket (located inside the meter case) must be used. DO NOT use the special bracket if a 1/4 turn lock is used. High capacity meter case models with Serial Nos. beginning 0910 through 1010 use 1/4 turn lock only.
Coin Drawer Security (Models with standard capacity meter case and high capacity meter case models starting with Serial Nos. beginning 1010) – for additional security, drill out the two pilot holes on each front side of the meter case to 1/4 or 5/16 inch (6.4 or 8.0 mm) holes and install a bicycle lock through these holes.
Additional Dryer Security
Located on the service door of the dryer is a flat Phillips head screw. During shipment, this screw is used to attach the service door to the meter case. For additional security, this screw can be reinstalled inside the control hood of your dryer. Following is the procedure for installing this screw:
1.Remove the Phillips head screw from service door. (Refer to Figure 34.)
2.Remove two screws holding control panel to control hood.
3.Tilt control panel forward and lay on a protective pad to prevent scratching of cabinet top.
4.Insert Phillips head screw down through double “D” hole in left rear corner of cabinet top (inside control hood) until it engages retainer nut located on left rear corner gusset of cabinet.
5.Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten screw. Torque of a power driver could
1
DRY2359N
DRY2359N
1Double “D” Hole
Figure 34
513005 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 25 |
