| TROUBLE | CAUSE | REMEDY |
|
|
|
Basket motor runs, but | Replace | |
basket will not revolve. |
|
|
Adjust belt tension. | ||
| Motor Pulley loose | Tighten set screw. |
| Basket overloaded | Removeload. |
| Not leveled | Refer to Installation Manual for proper leveling |
Dryer noisy or vibrating. |
| procedures. |
|
|
|
| Fan out of balance | Accidental damage to the fan blade can change the |
|
| dynamic balance. Damaged fans should be replaced. |
|
|
|
| Basket rubbing | Adjust basket clearance. |
| Tighten set screws; make sure sheaves are in proper | |
|
| alignment. |
| Belt | Adjust belt tension. |
| Foreign objects | Occasionally screws, nails, etc., will hang in the basket |
|
| perforations and drag against the sweep sheets |
|
| surrounding the basket. Such foreign objects should |
|
| be removed immediately. |
|
|
|
| Incorrect voltage | Check for correct control voltage - 24V. |
| No voltage | Check power supply, check secondary voltage on |
|
| transformer and check wiring and wiring diagram. |
| Spark igniter not sparking | May be broken or defective high voltage lead. Module |
Dryer runs but no heat. |
| not receiving correct input to ignite. Refer to Direct |
NOTE: This dryer has |
| Spark Ignition section. Make sure ignition module |
two ignition systems, |
| ground wire is securely grounded to the machine (both |
valves, etc. Be sure to |
| sides). |
check both systems. | Defective gas valve | Check continuity across unplugged valve. If defective, |
|
| replace coil assembly. |
| Gas turned off | Turnmanualgasvalve“ON”. |
|
|
|
Page 14