Programming

Agitation Step

Advance the cycle by pressing “∧” keypad to skip to the drain step. Filling, supply flushing and other signals turn off. Cycle remaining time is recalculated as the total remaining time after the agitation.

Drain Step

Advance the cycle by pressing “∧” keypad to skip the drain step and the following spin step. The spin step is skipped because the drain step needs to be completed to balance the load. The next programmed step after the spin begins. Cycle remaining is recalculated as the total remaining time after the drain and spin steps.

Spin Step

Advance the cycle by pressing “∧” keypad to skip the spin step. The next step after the spin begins. Cycle remaining is recalculated as the total remaining time after the spin step.

Temporary Free Mode

An authorized operator can enable a Free Cycle operation that overrides the programmed vend start amount. After running the Free Cycle, which can be any of the eight cycles, the control reverts to the usual programmed vend.

NOTE: The cycle counter DOES count the free cycle.

To run a temporary Free Cycle, follow the steps below. Enter PROGRAM Mode. Display shows “0000” or temperature or “tSFL” (depending on version of control).

Press the (∨) keypad. Display shows “FrEE”.

While display shows “FrEE”, return the Program/Run switch to the RUN position. Then press a cycle keypad to select one of the eight cycles. Press START (Enter) to begin the cycle. When the cycle concludes, vend reverts to the programmed amount.

Test Cycle

The test cycle provides a convenient means of troubleshooting and testing all machine functions quickly.

1.Enter PROGRAM Mode. Display shows “0000” or temperature or “tSFL” (depending on version of control).

2.Press the (∨) keypad. Display shows “FrEE”.

3.Press the START (Enter) keypad. Display shows “tESt”.

4.Return the Program/Run switch to the right. Display will show the vend price.

5.Enter coins or make payment so that the vend amount counts down. When vend is satisfied, the display will show “tESt” and the START (Enter) keypad LED will flash on and off. Press the START (Enter) keypad to begin the test cycle.

6.Press START (Enter) keypad. The door locks and the TEST Mode starts.

7.Display shows “SPC?”. This is a special factory test procedure. Simply ignore it and the machine will advance into the test cycle after about five seconds or go to “bAL?” if variable-speed.

NOTE: For variable-speed models ONLY, display shows “bAL?”. This is a factory test. Disregard the display. Machine will begin the test cycle after a few seconds.

28

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232157