Programming Cycle Segments

NOTE: Each cycle program can be customized within the 11 program segments contained in a cycle. A time must be entered for each segment. To skip a segment or spin, set the time to “00” and press Start (#) key. Refer to Table 3 for time parameters.

Time Parameters

Segment

Minimum

Maximum

 

 

 

PreWash “PrE”

2 minutes

30 minutes

 

 

 

Wash “UASH”

2 minutes

20 minutes

 

 

 

Fill 1 – Fill 9

2 minutes

15 minutes

“FIL1”... “FIL9”

 

 

 

 

 

Intermediate Spin

30 seconds

240 seconds

 

 

 

Final Spin

1 minute

10 minutes

 

 

 

 

Table 3

 

NOTE: Spin times in cycle segments 1 – 10 are entered in seconds (30 to 240), and time for final spin in segment 11 is entered in minutes (1 to 10).

6.Press Up (arrow) key until display shows segment to be edited. Press Start (#) key.

7.Use Up or Down (arrow) key to select Segment Time. Set this value to “00” to skip segment. Press Start (#) key.

8.If Temperature-Controlled Fill Setup Option is enabled, display will show “tFIL”. Press Start (#) key.

9.Use Up or Down (arrow) key to select Fill Temperature: Cold (“CFIL”), Hot (“HFIL”), Warm (“bFIL”) or Auxiliary (“AFIL”). Press Start (#) key.

NOTE: An auxiliary fill is available only if

“SUP5”/“AFIL” setup option is set to “AFIL”.

10.Use Up or Down (arrow) key to select Fill Level: Low (“Lo”), Medium (“nEd”) or High (“HI”). Press Start (#) key.

Programming

11.Use Up or Down (arrow) key to select Supply Option. Refer to Table 4.

 

Supply Options

 

 

 

Display

 

Supply

 

 

 

SUP0

 

No Supply

 

 

 

SUP1

 

Supply 1

 

 

 

SUP2

 

Supply 2

 

 

 

SUP3

 

Supply 3

 

 

 

SUP4

 

Supply 4

 

 

 

SUP5

 

Supply 5*

 

 

 

SUP6

 

Supply 1 and 5*

 

 

 

SUP7

 

Supply 3 and 4

 

 

 

*This is available only if the “SUP5”/“AFIL” setup option is set to “SUP5”.

Table 4

12.Press Start (#) key.

13.Use Up or Down (arrow) key to select Segment Temperature: 75° to 200°F or 25° to 93°C. Set this value to zero to disable auxiliary heat and temperature-controlled fill. Press Start (#) key.

NOTE: Only available if Temperature-Controlled Fill or Auxiliary Heat Setup Option is enabled.

WARNING

To prevent personal injury, avoid contact with inlet water temperatures higher than 125° Fahrenheit (51° Celsius) and hot surfaces.

W748

F232141

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

11