Programming
14.Use Up or Down (arrow) key to select Drain Option: “drAI” (drain) or “nodr” (no drain).
NOTE: The drain step in the final segment cannot be skipped.
15.For VNV models only, select spin speed for Fill 9: “SPn1” (Low), “SPn2” (Medium), or “SPn3” (High).
16.Display will flash “SPIn” and “tInE”. Use Up or Down (arrow) key to select spin time: 1 to
10 minutes (00 for no spin). Press Start (#) key. The display will show the identifier for the next program segment.
17.Press the Stop (*) key to complete the cycle programming procedure.
To select test cycle:
1.Flip program switch to up position (RUN Mode).
2.Press Down (arrow) key. Display will show “tESt” and “CYC”.
3.Press Start (#) key to begin.
The ability to advance to the next cycle step is possible by pressing the Start (#) key.
Refer to the following Cycle Charts section for detailed description of cycles.
12 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | F232141 |