Alliance Laundry Systems manual 16

Safety

Theory Of Operation (Continued)

S-Computer

The S-computer control is a programmable solid- state control capable of storing and running up to 30 cycles. A detailed description of these cycles can be found in the Programming section of this manual under S-computer Standard OPL Cycles.

If this machine’s computer has been equipped with special preprogrammed cycles, a separate insert listing these cycles has been included in the resealable plastic bag which contained this manual.

Note: Never turn the power off while the computer mode switch is in the PROGRAM position. Such action will disorder portions of the programmed data, necessitating reprogramming of some or all of the existing cycles. Always return the mode switch to RUN position before turning the power off.

Keypad

Operation of the S-computer control is performed with a 4-key touch keypad and LED display located on the front of the machine. See Figure 3. The following table describes the function of the individual keys when the machine is in RUN mode.

	Keypad
Key	Description
Up	Used in cycle selection; pressing this key
	moves among cycles from smaller to greater.
Down	Used in cycle selection; pressing this key
	moves among cycles from greater to smaller.
Start	Used to start a cycle.
Stop	Used to stop a cycle.

LED Display

Up Down Start Stop

B008RE3A

Figure 3

14 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F232073