Installation
Additional Washer Security
(Coin Models Only)
Located on the service door of the washer is a flat Phillips head screw. During shipment, this screw is used to attach the service door to the meter case. For additional security, this screw can be reinstalled inside the control hood of your washer. Refer to instructions below for installation.
•Bit (No. 8 screws) Part No. 281P4
•Bit (No. 12 screws) Part No. 282P4
•Bit Holder (3/8 drive) Part No. 24161
•Control panel
•Front panel
The following list is the procedure required to install the Phillips head screw and
WARNING
Any disassembly requiring the use of tools must be performed by a suitably qualified service person.
W299
To reduce the risk of electric shock, fire, explosion, serious injury or death:
•Disconnect electric power to the washer before servicing.
•Never start the washer with any guards/ panels removed.
•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the washer is properly grounded.
W003
1.Remove the Phillips head screw from service door (refer to Figure 14).
2.Remove two screws holding control panel to control hood.
3.Tilt control panel forward and lay on a protective pad to prevent scratching of cabinet top.
4.Insert Phillips head screw down through double “D” hole in left rear corner of cabinet top (inside control hood) until it engages retainer nut located on left rear corner gusset of cabinet.
5.Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten screw. Torque of a power driver could
6.Secure control panel to control hood using two No. 8
7.Remove two screws holding front panel to base of washer and install two No. 12
2
1
3
TLW2102N
135528 No. 8 Screws
2Double “D” Hole
335527 No. 12 Screws
Figure 14
14 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 202068 |