Allied Telesis 2.6.1 manual Stp

Layer 2 Switching	65
Table 7: Parameters in the output of the SHOW SWITCH PORT command
Parameter	Meaning
Configured speed/duplex	The port speed and duplex mode configured for this port.
	One of “Autonegotiate” or a combination of a speed (one
	of “10 Mbps”, “100 Mbps” or “1000 Mbps”) and a duplex
	mode (one of “half duplex” or “full duplex”).
Actual speed/duplex	The port speed and duplex mode that this port is actually
	running at. A combination of a speed (one of “10 Mbps”,
	“100 Mbps” or “1000 Mbps”) and a duplex mode (one of
	“half duplex” or “full duplex”).
Configured master/slave mode The master/slave mode configured for this port; one of
	“Autonegotiate’, “Master”, “Slave” or “Not applicable”.
Actual master/slave mode	The master/slave mode actually selected; one of “-”,
	“Master”, “Slave” or “Not applicable”.
Acceptable Frames Types	The value of the Acceptable Frames Type parameter, one of:
	“Admit All Frames” or “Admit Only VLAN-tagged Frames”.
Broadcast rate limit	The limit of the rate of reception of broadcast frames for
	this port, in frames per second.
Multicast cast rate limit	The limit of the rate of reception of multicast frames for this
	port, in frames per second.
DLF rate limit	The limit of the rate of reception of DLF (destination lookup
	failure) frames for this port, in frames per second.
Learn limit	The number of MAC addresses that may be learned for this
	port. Once the limit is reached, the port is locked against
	any new MAC addresses. One of “None” or a number from
	1 to 256.
Intrusion action	The action taken on this port when a frame is received from
	an unknown MAC address when the port is locked. One of
	“None”, “Discard”, “Trap” or “Disable”.
Current learned, lock state	The number of MAC addresses currently learned on this
	port and the state of locking for this port. The lock state is
	one of “not locked”, “locked by limit” or “locked by
	command”.
Mirroring	The traffic mirroring for traffic in and out of this port. One
	of “None”, “Rx” (for traffic received by this port), “Tx” (for
	traffic sent on this port) or “Both”. The port to which
	mirrored frames are being sent is also displayed.
Is this port mirror port	Whether or not this port is a mirror port. One of “No” or
	“Yes”.
Enabled flow control(s)	Flow control parameters set for the port; “Pause” or “-”. If
	flow control is implemented on the switch, then Pause flow
	control is applied to the port.
Send tagged pkts for VLAN(s)	The name and VLAN Identifier (VID) of the tagged VLAN(s),
	if any, to which the port belongs.
Port-based VLAN	The name and VLAN Identifier (VID) of the port-based VLAN
	to which the port belongs.
Ingress Filtering	The state of Ingress Filtering: one of “ON” or “OFF”.
Trunk Group	Name of trunk group to which the port belongs, if any.
STP	The name of the STP to which the port belongs.

Software Release 2.6.1 C613-02039-00 REV A