Allied Telesis 86241-02 manual PCR 02346 Module BGP, IPGNetwork affecting No

6Patch Release Note

PCR: 02346 Module: BGP, IPGNetwork affecting: No

It is now possible to set a preference value for dynamically learned routes based on their protocol using the command:

SET IP ROUTE PREFERENCE={DEFAULT1..65535}

PROTOCOL={BGP-EXTBGP-INTOSPF-EXT1OSPF-EXT2OSPF-INTER

OSPF-INTRAOSPF-OTHERRIP}

PCR: 02347 Module: SWI Network affecting: No

The CREATE CONFIGURATION command was not correctly generating the DISABLE SWITCH HWFILTER and DISABLE SWITCH L3FILTER commands. This issue has been resolved.

PCR: 02348 Module: ENCO Network affecting: No

When the PAC card was under severe load, the related driver occasionally did not fully transfer all result data from the chip. This caused an actCmdFail error. This issue has been resolved.

PCR: 02354 Module: SCC, SYN, PPP Network affecting: No

In a previous patch, a fatal error occurred after a RESTART ROUTER command was executed when using PPP over SYN. Also, on AR745 models, PPP was using an 8 MB boundary instead of a 16 MB boundary. These issues have been resolved.

PCR: 02357 Module: FR Network affecting: No

The following issues have been resolved:

•PIM was not sending Hello messages over a Frame Relay (FR) interface.

•A fatal error occurred if 64 was entered as the interface value in the DESTROY FRAMERELAY command. The command now only accepts 0-63 for this parameter.

•The ADD FRAMERELAY DLC command incorrectly accepted a TYPE parameter. Also, this command was not accepting the ENCAPSULATION parameter.

•The CREATE CONFIGURATION command incorrectly generated the CIR and CIRLIMITED parameters for the ADD FRAMERELAY DLC command.

•FR interfaces with static DLCs were always shown as DOWN. The status of the interface was not being updated when a circuit was added to the interface.

PCR: 02359 Module: IPG Network affecting: No

When an IP Multihomed interface was used as an OSPF interface, neighbour relationships were only established if the IP interface for OSPF was added first in the configuration. Now, OSPF establishes neighbour relationships regardless of the IP Multihomed interface configuration order.

PCR: 02363 Module: FFS, FILE, TTY Network affecting: No

The FLASH compaction process is now transparent to the file edition process. The FLASH system is now more stable.

Patch 86241-02 for Software Release 2.4.1 C613-10340-00 REV B