Getting Started
SOURCE/ |
|
|
|
POWER | MUTE | RESET | Rotary encoder |
MENU | GlideTouch bar | c |
7 Adjust “Minute” by turning the Rotary encoder by repeating steps 5 and 6.
8 After setting, press and hold MENU for at least 2 seconds to return to normal mode.
•To synchronize the clock to another clock/watch or radio time announcement, press and hold the Rotary encoder for at least 2 seconds after setting the “hour.” Minutes will reset to 00.
If the display shows over “30” minutes when you do this, the time will advance one hour.
•If MENU is pressed while adjusting or setting the items in the MENU mode, the unit will return to the previous selection screen.
•By pressing the GlideTouch bar under RETURN in the MENU mode, the unit will return to the normal mode.
•If no operation is performed for 60 seconds, the unit will return to the normal mode.
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
•The unit can be turned on by pressing any other button except TITLE and eject c.
Opening and Closing the Movable Display
Press c.
The movable display will open.
Press and hold SOURCE/POWER for at least 2 seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after installing the CD changer, after changing the car battery, etc.
1 Turn off the unit power.
2 Press RESET with a
Setting Time
1 Press MENU.
2 Select SETUP by sliding your finger on the GlideTouch bar to the left or right. Press the GlideTouch bar under SETUP.
The main SETUP menu is displayed.
3 Select GENERAL by sliding your finger on the GlideTouch bar to the left or right.
Press the GlideTouch bar under GENERAL.
The GENERAL SETUP menu is displayed.
4 Select CLOCK by sliding your finger on the GlideTouch bar to the left or right. Press the GlideTouch bar under CLOCK.
5 Select “Hour” by sliding your finger on the GlideTouch bar to the left or right.
6 Adjust “Hour” by turning the Rotary encoder.
To close the movable display, press c again.
The movable display will close.
•Do not apply shock to the movable display when it is open as it may result in malfunction of the unit.
•The display may be dim during low temperatures and immediately after turning on the power. The brightness will return to normal as time elapses.
•The display will stop at the set tilt angle when closing.
Caution
Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch.
