Installation
Air ventilation hole
Rear of the Unit
Caution
Do not block the unit’s fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Caution
When you install this unit in your car, do not remove the detachable front panel.
If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.
The main unit must be mounted within 35 degrees of the horizontal plane, back to front.
Detachable Front
Panel
Less than 35°
1Remove the mounting sleeve from the main unit (refer to “Removal” on page 48).
Mounting Sleeve (Included)
Dashboard
Pressure Plates*
This unit
*If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem.
2Reinforce the head unit with a metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the
vehicle’s chassis.
Connect each input lead coming from an amplifier to the corresponding output lead coming from the left rear of the
Hex Nut (M5) | Screw |
| *2 |
| Bolt Stud |
Metal
Mounting
Strap
*1
This unit
Ground Lead
Chassis
Note
•For the screw marked “*2”, use an appropriate screw for the chosen mounting location.
3Slide the
Install the detachable front panel.
Removal
1Remove the detachable front panel.
2Insert the bracket keys into the unit, along the guides on either side. The unit can now be removed from the mounting sleeve.
This unit
Bracket keys (Included)
