Alpine CDA-7865R owner manual Multi-Changer Selection, Searching for Titled Discs CD Changer only

Press and hold the T.S.M. button for at least 2 seconds. The title blinks in the display.

CD Player Operation

SOURCEBAND/T.S.M

DN g f UP

Searching for Titled Discs (CD Changer only)

If a CD is titled, you can do a search for it. (To title CDs, refer to "Titling Discs" on page 18.)

1

2 Press the DN g or f UP button to select the desired disc title.

3 Press the T.S.M. button to play the selected disc. The unit will automatically search for the disc and begin play.

4 Press the T.S.M. button for at least 2 seconds to cancel the disc searching mode.

NOTE

This function cannot be performed when using a multi- changer switching device.

Multi-Changer Selection

Alpine's Ai-NET system will support up to 6 CD Changers. When operating two or more changers, the KCA-400C (Multi-Changer Switching device) must be used. If you use 1 Switching device, you can connect up to 4 CD Changers. If you use 2 Switching devices, you can connect up to 6 CD Changers.

1 Press the SOURCE button on the CDA-7865R to activate the CD Changer mode.

Alternatively, press the SOURCE button on the Remote Control (RUE-4185) to activate the CD Changer mode. Proceed to Step 3 below to select the desired CD Changer.

CD-CHG
BAND	SOURCE	A.PROC
PROG
BAND		SOURCE

REMOTE CONTROL UNIT RUE-4185

2 Press the BAND button on the CDA-7865R or the RUE-4185 to activate the CD Changer Selection mode.

3 The CD Changer Selection mode remains active for 3 seconds after Step 2 is performed. Press the BAND button until the desired CD Changer indicator appears on the display.

NOTE

If the selected CD Changer is not connected, the display will show "NO CHGRX."

Alternatively press the BAND button on the Remote Control until the desired changer indicator appears on the display.

4 To operate the selected changer, see "CD Operation" section.

20-EN