Receiving RDS Regional (Local) Stations
1
2 Press the fUP button repeatedly to select "REG" Each press of the fUP button scrolls the modes as shown:
→
DEMO ← AUX ← SCR ← MUTE ← BEEP ←
NOTE
If you press the DN gbutton the display scrolls in reverse sequence.
3 Press the TUNE button to turn on or off the REG (Regional) mode.
In the REG OFF mode, the unit automatically keeps receiving the related local RDS station.
4 Press and hold the INTLZ button for at least 2 seconds to deactivate the setting mode.
Receiving Traffic Information
1 Press the T.INFO button to activate the Traffic Information mode.
To cancel the Traffic information mode, press the T.INFO button again.
2 Press the DN gor fUP button to select your desired traffic information station. When a traffic information station is tuned in, the TP indicator lights up.
Traffic information is heard only when it is being broadcast. If traffic information is not being broadcast, the unit is set in the standby mode. When a traffic information broadcast begins, the unit automatically receives it and the display shows
When traffic information broadcast is over, the unit will automatically set in the standby mode.
NOTES
•If the traffic information broadcast signal falls below a certain level, the unit remains in the receiving mode for 1 minute. If the signal remains below a certain level for over 1 minute, the "T.INFO" indicator blinks.
•If you do not want to listen to the traffic information being received, lightly press the T.INFO button to skip that traffic information message. The T.INFO mode will remain in the ON position to receive the next traffic information message.
•If the volume level is changed while receiving traffic information, the changed volume level will be memorized. When traffic information is received next time, the volume level will be automatically adjusted to the level memorized.
•In the T.INFO mode, the SEEK tuning selects only the TP stations.
PTY (Programme Type) Tuning
1 Press the "F" button. The FUNC indicator will illuminate.
2 Press the PTY button to activate the PTY mode. The Programme Type of the station being currently received will be displayed for 5 seconds.
•If there is no receivable PTY broadcast, "NO PTY" will be displayed for 5 seconds.
•If no RDS station can be received, the display shows "NO PTY."
NOTE
If no button is pressed within 5 seconds after pressing the PTY button, the PTY mode will be automatically cancelled.
3 Press the DN gand fUP buttons within 5 seconds after activating the PTY mode to choose the desired programme type while the PTY (programme type) is being displayed. Each press scrolls the programme type by one.
→LIGHT M → CLASSICS → OTHER M
4 Press the PTY button within 5 seconds after selecting the programme type to start searching for a station in the selected programme type. The chosen programme type indicator blinks during searching and lights when a station is found.
If no station is found, "NO PTY" will be displayed for 5 seconds.
5 Press the "F" button to activate the normal
mode. The FUNC indicator will turn off.
NOTE
Operate the unit while the FUNC indicator is illuminated.
If no buttons are pressed within 5 seconds, the FUNC indicator will turn off.
