Display Angle Adjustment |
| Turning Loudness On/Off |
Movable display
The movable display may be adjusted to 3 different angles depending upon user preference.
1 Press the ANGLE 8 or 9 button to adjust the angle of the movable display.
NOTES
•The display will close a half minute after the ignition key is turned to the OFF position.
•The adjusted angle of the display is stored in memory. There is no need to
CAUTION
Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch.
Adjusting Volume/Bass/Treble/
Balance (Between Left and Right)/
Fader (Between Front and Rear)
1 Press the MODE (Audio Control) knob repeatedly to choose the desired mode. Each press changes the modes as follows:
→ VOL → BAS →TRE
FAD ← BAL ←
NOTES
•If the MODE (Audio Control) knob is not rotated in 5 seconds after selecting the BASS, TREBLE, BALANCE, or FADER mode, the unit automatically returns to the VOLUME mode.
•When the subwoofer or BBE mode is ON, their respective levels may be adjusted.
2 Rotate the MODE (Audio Control) knob until the desired sound is obtained in each mode.
NOTES
•The settings of the Bass and Treble will be individually memorized for each source (FM, MW (LW) and CD) until the setting is changed. Depending on the connected devices, some functions and display indications do not work.
•When the temperature inside the unit rises, the volume may decrease momentarily. This is not a malfunction.
Loudness introduces a special low- and high- frequency emphasis at low listening levels. This compensates for the ear's decreased sensitivity to bass and treble sound.
1 Press and hold the MODE (Audio Control) knob for at least 2 seconds to activate or deactivate the loudness mode.
The display shows "LOUDNESS" when the loudness mode is activated.
NOTE
When an external audio processor is connected to this unit, the Loudness function on this unit does not work.
Selecting BBE Mode
The BBE (Barcus Berry Electronics) processor installed in this unit is designed to correct the phase distortion inherent in most loudspeaker designs. Ensuring the phase integrity of the signal driving the speakers improves the accurate reproduction of the sound.
1 Press and hold the BBE button for at least 2 seconds to turn on and off the BBE mode.
2 In BBE mode, press the MODE (Audio Control) knob to select the BBE adjusting mode.
Each press changes the adjusting mode.
3 To change to a desired BBE level, rotate the MODE (Audio Control) knob.
The BBE level can be changed from +1 to +3.
NOTE
The initial mode is +2.
